Show
Sort by
-
- Journal Article
- A1
- open access
Evaluation of copper slag and stainless steel slag as replacements for blast furnace slag in binary and ternary alkali-activated cements
-
Antiproliferative activity of Dioclea violacea lectin in CaCO3 particles on cancer cells after controlled release
-
Ag-functionalized Bi2W(Mo)O-6/PVDF membrane for photocatalytic water treatment
-
Combining carbon nanotube foam with nanosilver/silicone resin or graphene foam for advanced metamaterial design
-
Mesoporous TiO2 from poly(N,N-dimethylacrylamide)-b-polystyrene block copolymers for long-term acetaldehyde photodegradation
-
Grain and texture evolution in nano/ultrafine-grained bimetallic Al/Ni composite during accumulative roll bonding
-
Enhancement of the acetone sensing capabilities to ppb detection level by Fe-doped three-dimensional SnO2 hierarchical microstructures fabricated via a hydrothermal method
-
Influence of grain size on the electrochemical behavior of pure copper
-
Structural and catalytic properties of Au/MgO-type catalysts prepared in aqueous or methanol phase : application in the CO oxidation reaction
-
- Journal Article
- A1
- open access
Tuning the acidic-basic properties by Zn-substitution in Mg-Al hydrotalcites as optimal catalysts for the aldol condensation reaction
-
Crosslinking strategies for porous gelatin scaffolds
-
Microwave-assisted synthesis of mesoporous titania with increased crystallinity, specific surface area, and photocatalytic activity
-
Functionalized metal-organic-framework CMPO@MIL-101(Cr) as a stable and selective rare earth adsorbent
-
pH-sensitive superabsorbent polymers: a potential candidate material for self-healing concrete
-
Modeling the crystallographic changes in processing of Al alloys
-
Structural dependence of gold deposition by nanoplating in polycrystalline copper
-
Effect of the relative humidity on the fibre morphology of polyamide 4.6 and polyamide 6.9 nanofibres
-
Polyamide 6.9 nanofibres electrospun under steady state conditions from a solvent/non-solvent solution
-
Improved photocatalytic activity of polymer-modified TiO₂ films obtained by a wet chemical route
-
The effect of temperature and humidity on electrospinning
-
Surface energy controlled α-γ-α transformation texture and microstructure character study in ULC steels alloyed with Mn and Al
-
Electrospinning of chitosan nanofibrous structures: feasibility study
-
- Journal Article
- A1
- open access
Production of amorphous Fe-B alloy and alpha-Fe by chemical reduction of hematite using sodium borohydride
-
Low-field magnetoresistance in La0.7Ca0.3MnO3 manganite compounds prepared by the spray drying technique
-
Use of a calcium phosphate matrix as a temporary cast for bony defect repair: a pilot study
-
The effects of Cs addition and different sintering conditions on YSCO-123 superconductors made from precursor or commercial 123 powder
-
YBa2Cu3O7-x superconductive tapes and wires : a peritectic sintering procedure to improve the quality