Show
Sort by
-
The pyrolysis study of polybutadiene rubber under different structural and process parameters : comparison with polyvinyl chloride degradation
-
Design and cost comparison of district heating and cooling (DHC) network configurations using ring topology : a case study
-
Identification of multi-scale homogeneity of blended cement concrete : macro performance, micro and meso structure
-
- Journal Article
- A1
- open access
A detailed experimental and kinetic modeling study on pyrolysis and oxidation of oxymethylene ether-2 (OME-2)
-
The pyrolysis of oak with polyethylene, polypropylene and polystyrene using fixed bed and stirred reactors and TGA instrument
-
Thermocatalytic degradation of common polymers : a microscale combustion calorimetry study
-
Crystallization kinetics of binary Yb2O3-Al2O3 glass
-
Effect of operating conditions and feedstock composition on the properties of manganese oxide or quartz charcoal pellets for the use in ferroalloy industries
-
- Journal Article
- A1
- open access
Cost-effective flexibilisation of an 80 MWe retrofitted biomass power plants : improved combustion control dynamics using virtual air flow sensors
-
Crystallization kinetics of Ni-doped Ca2Al2SiO7 glass microspheres
-
Analysis and modelling of the relation between the shear rate and Reynolds stress tensors in transitional boundary layers
-
Hot water storage for increased electricity production with organic Rankine cycle from intermittent residual heat sources in the steel industry
-
Flame behavior from opening of a compartment with ambient back-roof wind passing through the roof : experiments and similarity analysis
-
On the use of dynamic turbulence modelling in fire applications
-
Influence of centralized and distributed thermal energy storage on district heating network design
-
Modeling temperature evolution of wheel flat during formation
-
- Journal Article
- A1
- open access
Heat transfer from an immersed fixed silver sphere to a gas fluidised bed of very small particles
-
LES study of a turbulent spray jet : mesh sensitivity, mesh-parcels interaction and injection methodology
-
- Journal Article
- A1
- open access
Gas solid contacting measurements in a turbulent fluidized bed by oxidation of carbon monoxide
-
On the environmental and economic issues associated with the forestry residues-to-heat and electricity route in Chile : sawdust gasification as a case study
-
Large eddy simulations of a set of experiments with water spray-hot air jet plume interactions
-
An automated GIS-based planning and design tool for district heating : scenarios for a Dutch city
-
Kinetics of thermal decomposition of PMMA at different heating rates and in a wide temperature range
-
- Journal Article
- A1
- open access
Study of the importance of non-uniform mass density in numerical simulations of fire spread over MDF panels in a corner configuration
-
Variable volume ratio free-piston expander : prototyping and experimental campaign
-
- Journal Article
- A1
- open access
Experimental study of the effectiveness of air curtains of variable width and injection angle to block fire-induced smoke in a tunnel configuration
-
Analysis of an organic Rankine cycle with liquid-flooded expansion and internal regeneration (ORCLFE)
-
Assessment of an evaporation model in CFD simulations of a free liquid pool fire using the mass transfer number approach
-
Investigation of low-frequency-oscillating water flow in metal foam with 10 pores per inch
-
Placement and sizing of multiple distributed generation and battery swapping stations using grasshopper optimizer algorithm
-
- Journal Article
- A1
- open access
Increasing exhaust temperature to enable after-treatment operation on a two-stage turbo-charged medium speed marine diesel engine
-
Experimental study of the thermal characteristics of a heat pipe
-
On soot and radiation modeling in buoyant turbulent diffusion flames
-
Temperature rise around nanoparticles
-
- Journal Article
- A1
- open access
Hydrodynamic experiments on a small-scale circulating fluidized bed reactor at elevated operating pressure, and under an O2/CO2 environment
-
Towards low carbon business park energy systems : a holistic techno-economic optimisation model
-
Thermal behaviour of yttrium aluminate glasses studied by DSC, high-temperature X-ray diffraction, SEM and SEM–EDS
-
Design sensitivity analysis of a plate-finned air-cooled condenser for low-temperature organic rankine cycles
-
In situ catalytic fast pyrolysis of crude and torrefied Eucalyptus globulus using carbon aerogel-supported catalysts
-
Sensitivity analysis of heat losses in collective heat distribution systems using an improved method of EPBD calculations
-
Thermal fouling of heat exchanger tubes due to heavy hydrocarbon droplets impingement
-
- Journal Article
- A1
- open access
Large Eddy simulations of CH4 fire plumes
-
- Journal Article
- A1
- open access
Discussion on the effect of a fluid domain around fins and grid discretization in buoyancy-driven convection
-
- Journal Article
- A1
- open access
Simulation of the flow in a ribbed rotating duct with a hybrid k-ω RANS/LES model
-
- Miscellaneous
- open access
Advanced analysis of turbulent combustion preface
-
Energy penalty estimates for CO2 capture: comparison between fuel types and capture-combustion modes
-
- Journal Article
- A1
- open access
Experimental investigation of the effect of engine settings on the wall heat flux during HCCI combustion
-
Steady-state and dynamic validation of a small-scale waste heat recovery system using the ThermoCycle Modelica library
-
Heat transfer in premixed spark ignition engines part II : systematic analysis of the heat transfer phenomena
-
Experimental comparison of organic fluids for low temperature ORC (organic Rankine cycle) systems for waste heat recovery applications
-
- Journal Article
- A1
- open access
Heat transfer in premixed spark ignition engines part I : identification of the factors influencing heat transfer
-
Exergoeconomic evaluation of an ethanol-fueled solid oxide fuel cell power plant
-
Multi-period analysis of heat integration measures in industrial clusters
-
Methodical thermodynamic analysis and regression models of organic Rankine cycle architectures for waste heat recovery
-
Large eddy simulation of fine water sprays: comparative analysis of two models and computer codes
-
Quantification of octanol-water partition coefficients of several aldehydes in a bubble column using selected ion flow tube mass spectrometry
-
- Journal Article
- A1
- open access
Experimental study of NOx reduction on a medium speed heavy duty diesel engine by the application of EGR (exhaust gas recirculation) and Miller timing
-
- Journal Article
- A1
- open access
Towards low carbon business park energy systems: classification of techno-economic energy models
-
Enthalpies of ligand substitution for [Mo(eta(C5H5)-C-5)(CO)(2)(NO)] : the role of pi-bonding effects in metal-ligand bond strengths
-
- Journal Article
- A1
- open access
LES-CMC simulations of different auto-ignition regimes of hydrogen in a hot turbulent air Co-flow
-
Particle deposition effects on heat transfer from a metal foam-wrapped tube bundle
-
Large Eddy simulations of the flow in the near-field region of a turbulent Buoyant Helium plume
-
Les-CMC simulations of a turbulent lifted hydrogen flame in vitiated co-flow
-
Predictions of round impinging jet heat transfer with two k-omega hybrid RANS/LES models
-
- Journal Article
- A1
- open access
Sustainable and efficient energy consumption of corn production in Southwest Iran: combination of multi-fuzzy and DEA modeling
-
A comprehensive study of methyl decanoate pyrolysis
-
Potential of zeotropic mixtures as working fluids in organic Rankine cycles
-
The Cattaneo type space-time fractional heat conduction equation
-
- Journal Article
- A1
- open access
Simulation of hydrogen auto-ignition in a turbulent co-flow of heated air with LES and CMC approach
-
Simulation of impinging jet mass transfer at high Schmidt number with algebraic models
-
Verifying the spin of centrifuges
-
- Journal Article
- A1
- open access
Generalised langevin model in correspondence with a chosen standard scalar-flux second-moment closure
-
Influence of interface materials on the thermal impedance of electronic packages
-
Further development of a dynamic intermittency model for wake-induced transition
-
A Stable Pressure-Correction Scheme for Time-Accurate Non-Premixed Combustion Simulations
-
Joint Scalar versus Joint Velocity-Scalar PDF Simulations of Bluff-Body Stabilized Flames with REDIM
-
Comparison of two unsteady intermittency models for bypass transition prediction on a turbine blade profile
-
Comparative study of micromixing models in transported scalar PDF simulations of turbulent nonpremixed bluff body flames
-
Study of the performance of three micromixing models in transported scalar PDFsimulations of a piloted jet diffusion flame ("Delft Flame III")
-
Micro-CHP systems for residential applications
-
Intermittency based RANS bypass transition modelling
-
Computing in finite time
-
A Mach-uniform pressure-correction algorithm with AUSM plus flux definitions
-
Flow and mixing fields for transported scalar PDF simulations of a piloted jet diffusion flame ('Delft Flame III')
-
Statistical modeling of thermal radiation transfer in buoyant turbulent diffusion flames