Academic Bibliography

Search 200 years of publications by Ghent University researchers.

dr. ir. Christophe T'Joen

Faculty of Engineering and Architecture > Department of Electromechanical, Systems and Metal Engineering

Work address: Sint-Pietersnieuwstraat 41
9000 Gent
Email: Christophe.TJoen@UGent.be

Show Sort by

Add to list
Steady-state and dynamic behavior of a moderated molten salt reactor

K Nagy, D Lathouwers, Christophe T'Joen (UGent) , JL Kloosterman and THJJ van der Hagen

(2014) ANNALS OF NUCLEAR ENERGY. 64. p.365-379
Add to list
Calibration of a capacitive void fraction sensor for small diameter tubes based on capacitive signal features

Kathleen De Kerpel (UGent) , Bernd Ameel (UGent) , Sven De Schampheleire (UGent) , Christophe T'Joen (UGent) , Hugo Canière (UGent) and Michel De Paepe (UGent)

(2014) APPLIED THERMAL ENGINEERING. 63(1). p.77-83
Add to list
Investigation of the thermal development length in annular upward heated laminar supercritical fluid flows

JWR Peeters, Christophe T'Joen (UGent) and M Rohde

(2013) INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER. 61. p.667-674
Add to list
Particle deposition effects on heat transfer from a metal foam-wrapped tube bundle

Mostafa Odabaee, Michel De Paepe (UGent) , Peter De Jaeger (UGent) , Christophe T'Joen (UGent) and Kamel Hooman

(2013) INTERNATIONAL JOURNAL OF NUMERICAL METHODS FOR HEAT & FLUID FLOW. 23(1). p.74-87
Add to list
Flow regime based calibration of a capacitive void fraction sensor for small diameter tubes

Kathleen De Kerpel (UGent) , Bernd Ameel (UGent) , Christophe T'Joen (UGent) , Hugo Canière (UGent) and Michel De Paepe (UGent)

(2013) INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID. 36(2). p.390-401
Add to list
Comparison of different testing methods for gas fired domestic boiler efficiency determination

Michel De Paepe (UGent) , Christophe T'Joen (UGent) , Henk Huisseune (UGent) , Marnix Van Belleghem (UGent) and V Kessen

(2013) APPLIED THERMAL ENGINEERING. 50(1). p.275-281
Add to list
- Journal Article
- A1
- open access
Influence of geometrical parameters of open-cell aluminum foam on thermohydraulic performance

Peter De Jaeger (UGent) , Christophe T'Joen (UGent) , Henk Huisseune (UGent) , Bernd Ameel (UGent) , Sven De Schampheleire (UGent) and Michel De Paepe (UGent)

(2013) HEAT TRANSFER ENGINEERING. 34(14). p.1202-1215
Add to list
Experimental study of buoyancy-driven flow in open-cell aluminium foam heat sinks

Sven De Schampheleire (UGent) , Peter De Jaeger (UGent) , Robin Reynders (UGent) , Kathleen De Kerpel (UGent) , Bernd Ameel (UGent) , Christophe T'Joen (UGent) , Henk Huisseune (UGent) , Steven Lecompte (UGent) and Michel De Paepe (UGent)

(2013) APPLIED THERMAL ENGINEERING. 59(1-2). p.30-40
Add to list
Thermal hydraulic performance of 10 PPI aluminium foam as alternative for louvered fins in an HVAC heat exchanger

Sven De Schampheleire (UGent) , Peter De Jaeger (UGent) , Henk Huisseune (UGent) , Bernd Ameel (UGent) , Christophe T'Joen (UGent) , Kathleen De Kerpel (UGent) and Michel De Paepe (UGent)

(2013) APPLIED THERMAL ENGINEERING. 51(1-2). p.371-382
Add to list
Performance analysis of a compound heat exchanger by screening its design parameters

Henk Huisseune (UGent) , Christophe T'Joen (UGent) , Peter De Jaeger (UGent) , Bernd Ameel (UGent) , Sven De Schampheleire (UGent) and Michel De Paepe (UGent)

(2013) APPLIED THERMAL ENGINEERING. 51(1-2). p.490-501

1
2
3
4
…
12
13

Next →