Academic Bibliography

Search 200 years of publications by Ghent University researchers.

ir. Ilya T'Jollyn

Faculty of Engineering and Architecture > Department of Electromechanical, Systems and Metal Engineering

Work address: Technologiepark Zwijnaarde 131
9052 Zwijnaarde
Email: Ilya.TJollyn@UGent.be
ORCID iD: 0000-0003-3151-260X

Show Sort by

Add to list
- Journal Article
- A1
Modelling of a gas-fired heating boiler unit for residential buildings based on publicly available test data

Katarina Simić (UGent) , Ilya T'Jollyn (UGent) , Willem Faes (UGent) , Josué Borrajo Bastero (UGent) , Jelle Laverge (UGent) and Michel De Paepe (UGent)

(2021) ENERGY AND BUILDINGS.
Add to list
- Conference Paper
- C1
- open access
Evaluation of high performance rotor cooling techniques for permanent magnet electric motors

Jasper Nonneman (UGent) , Brent Van der Sijpe, Ilya T'Jollyn (UGent) , Steven Vanhee, Joachim Druant and Michel De Paepe (UGent)

(2021) 2021 IEEE International Electric Machines & Drives Conference (IEMDC).
Add to list
- Conference Paper
Thermally Developing Laminar Flow and Heat Transfer Characteristics in a Three-sided Cusped Duct

Ilya T'Jollyn (UGent) , Jasper Nonneman (UGent) and Michel De Paepe (UGent)

(2021) Proceedings of the 15th International Conference on Heat Transfer, Fluid Mechanics and Thermodynamics (HEFAT2021). p.2234-2238
Add to list
A charging time energy fraction method for evaluating the performance of a latent thermal energy storage heat exchanger

Wim Beyne (UGent) , Kenny Couvreur (UGent) , Ilya T'Jollyn (UGent) , Robin Tassenoy (UGent) , Steven Lecompte (UGent) and Michel De Paepe (UGent)

(2021) APPLIED THERMAL ENGINEERING. 195.
Add to list
- Conference Paper
- P1
- open access
Quality assessment of a 2D FE based lumped parameter electric motor thermal model using 3D FE models

Jasper Nonneman (UGent) , Ilya T'Jollyn (UGent) , Peter Sergeant (UGent) and Michel De Paepe (UGent)

(2020) 2020 International Conference on Electrical Machines (ICEM). p.973-980
Add to list
Thermohydraulic modelling of microchannel winding cooling for electric machines

Ilya T'Jollyn (UGent) , Jasper Nonneman (UGent) and Michel De Paepe (UGent)

(2020) 2020 International Conference on Electrical Machines (ICEM). p.1004-1010
Add to list
- Conference Paper
- C1
- open access
Modelling and validation of a switched reluctance motor stator tooth with direct coil cooling

Jasper Nonneman (UGent) , Stephan Schlimpert, Ilya T'Jollyn (UGent) and Michel De Paepe (UGent)

(2020) 2020 19th IEEE Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems (ITherm), Proceedings. p.306-314
Add to list
- Conference Paper
- C1
- open access
Experimental study of inverter base plate cooling with two-phase pool boiling

Ilya T'Jollyn (UGent) , Jasper Nonneman (UGent) , Leonie Hallemans, Simon Ravyts, Johan Driesen and Michel De Paepe (UGent)

(2020) 33rd International Conference on Efficiency, Cost, Optimization, Simulation and Environmental Impact of Energy Systems (ECOS 2020). p.83-91
Add to list
- Conference Paper
- C1
- open access
Experimental study of a switched reluctance motor stator tooth with slot and end winding cooling

Jasper Nonneman (UGent) , Stephan Schlimpert, Ilya T'Jollyn (UGent) and Michel De Paepe (UGent)

(2020) 33rd International Conference on Efficiency, Cost, Optimization, Simulation and Environmental Impact of Energy Systems (ECOS 2020). p.2425-2435
Add to list
Pool boiling heat transfer measurements on a horizontal plate with a low global warming potential refrigerant

Ilya T'Jollyn (UGent) , Jasper Nonneman (UGent) and Michel De Paepe (UGent)

(2019) Proceedings of the 25th IIR International Congress of Refrigeration. p.1558-1564

1
2
3

Next →